איך להחליף את גוף החימום הקצר
The recoater cord is a consumable part and has to be replaced after 200-300 printing hours.
You will need: a new recoater cord and a 2mm hex wrench
- Turn the printer on and open the printer lid.
- Turn the printer off and unplug the power cable.
- Move the recoater arm by hand to the middle of the printing chamber.
- Remove two black screws on the side (Lisa)/top (Lisa Pro) of the recoater arm.
- Remove the black recoater cover.
- Unscrew the recoater cord from both sides. Mind the position of the spring.
- (Lisa) Unscrew the mounting plate off the cord.
- Remove the cord.
- Thread the new cord through the recoater arm. Mind the position of the spring.
- (Lisa) Screw the mounting plate to the new cord.
- Screw the recoater cord in place.
- Reinstall the recoater cover.
If you have any difficulties contact Mafil support.